Manuals / Wayne-Dalton / Household Appliance / Garage Door Opener

Wayne-Dalton 6100 Pull Down Rope, Tools Power drill, 1/8” Drill bit, Tape measure

Models: 6100

1 20

Download 20 pages 28.32 Kb

Page 16

Pull Down Rope

Pull Down Rope

Tools: Power drill, 1/8” Drill bit, Tape measure

WARNING

Do not install pull down rope on doors with operators. Children may become entangled in the rope causing severe or fatal injury.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the no. 6 screw eye and to the bottom corner bracket, as shown.

No. 6 Screw eye

Pull down rope

48” to 50” From ﬂoor

Pull down rope

Bottom corner bracket

16

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Image 16

Wayne-Dalton 6100 installation instructions Pull Down Rope, Tools Power drill, 1/8” Drill bit, Tape measure

Contents

IMPORTANT NOTICES T a b l e O f C o n t e n t s6100 models may have unique variations Parts BreakdownImportant Safety Instructions Package ContentsPre-Installation Tools RequiredDoor Section Identification Removing an Existing DoorPreparing the Opening Backroom Requirements BackroomHeadroom Requirements Page Pull Handles Cable Drum Assemblies and Track RollersBottom Section Vertical TracksTop Fixtures Stacking SectionsDrawbar Operator Bracket Top SectionHorizontal Tracks/Q.I Flag Angles Center Bracket Bushing Assembly Adjusting Top FixturesHorizontal Tracks/F.A. Flag Angles TorqueMaster Spring TubeSecuring Center Bracket Bushing Assembly Drum WrapsCable Drum Assemblies End BracketsWinding Springs Lift Cable AdjustmentsSecuring Drum Wraps Rear Back Hangs Balancing Door Optional Installation TorqueMaster Plus Reset InstructionsDoor Arm Hookup Inside LockPull Down Rope Tools Power drill, 1/8” Drill bit, Tape measureCleaning Your Garage Door Operation and MaintenanceMaintenance Painting Your Garage DoorNEVER REMOVE, ADJUST, OR LOOSEN THE BOLTS, SCREWS AND/OR LAG SCREWS ON THE COUNTERBALANCE END OR CENTER BEARING BRACKETS SYSTEM OR BOTTOM BRACKETS OF THE DOOR. THESE BRACKETS ARE CON- NECTED TO THE SPRINGS AND ARE UNDER EXTREME TENSION. TO AVOID POSSIBLE SEVERE OR FATAL INJURY, HAVE ANY SUCH WORK PERFORMED BY A TRAINED DOOR SYSTEMS TECHNICIAN USING PROPER TOOLS AND INSTRUCTIONS Warranty Lifetime Limited Warranty ModelPlease Do Not Return This Product To The Store Thank you for your purchase