Weber 41995 manual Lighting, To Extinguish

Operating Instructions
Lighting		1) Open the lid.
Summary lighting instructions are on the control panel.		2) Make sure all burner control knobs are turned OFF.
		(Push control knob down and turn clockwise to ensure
DANGER		that it is in the OFF position.)
Failure to open the lid while igniting the barbecue’s		WARNING: The burner control knobs must be in the
burners, or not waiting 5 minutes to allow the gas to		OFF position before turning on the liquid propane
clear if the barbecue does not light, may result in an		cylinder tank valve. If they are not in the OFF
explosive flame-up which can cause serious bodily		position, when you turn on the LP cylinder valve,
injury or death.		the “excess gas flow control” feature will activate,
		limiting the flow of gas from the LP cylinder. If this
Crossover® Ignition System		should occur, turn OFF the LP cylinder valve and
Note - The Crossover® ignition system ignites the set of left		burner control knobs. Then start over.
burners with a spark from the igniter electrode inside the		DANGER:
Gas Catcher™ ignition chamber. You generate the energy
		When the “excess gas flow control” feature is
for the spark by pushing the electronic ignition button.
		activated, a small amount of gas is still flowing to the
WARNING: Check hose before each use of
		burners. After turning OFF the cylinder knobs, wait at
barbecue for nicks, cracking, abrasions or cuts. If
		least 5 minutes for the gas to clear before attempting
the hose is found to be damaged in any way, do not
		to light the barbecue. Failure to do so may result in an
use the barbecue. Replace using only Weber®
authorized replacement hose. Contact the		explosive flame-up, which can cause serious bodily
		injury or death.
Customer Service Representative in your region
using the contact information sheet provided with		3) Turn the cylinder on by turning the cylinder valve
your manual.
		counterclockwise.
		WARNING: Do not lean over the open barbecue.
		4) Select the burner set you want to operate.
		5) Push LEFT burner control knob down and turn to
1		START/HI in selected burner set.
		6) Push igniter button and hold until burner ignites. You
		will hear the igniter sparking.
		7) Check that the burner is lit by looking through the
4,5,8		cooking grates. You should see a flame.
		WARNING: If the burner does not light, turn the
		LEFT burner control knob to OFF and wait 5
		minutes to let the gas clear before you try again or
7		try to light with a match.
		8) After the LEFT burner is lit you can turn on the RIGHT
		burner adjacent to it. The RIGHT burner lights from the
		LEFT burner.
2	3
6		To Extinguish
2		Push down and turn each burner control knob
		clockwise to the OFF position. Turn gas supply OFF at
		the source.

*The grill illustrated may have slight differences than the model purchased.

D-3