Install Igniter

Insert the igniter electrode and two 10-24 screws through the igniter bracket and the holes in the bottom unit on the side opposite the regulator.

Add washers and wing nuts, making sure that the wing nuts are secured in

a vertical position.

The igniter electrode has been pre-bent. It may need to be adjusted so the tip is approximately 1/8 inch from the holes in the burner tube.

DANGER

Make sure the tip of the igniter wire is adjusted to the holes in the burner tube. If it is not adjusted properly, gas can accumulate in the barbecue while igniting the barbecue. Delayed ignition of the accu- mulated gas may occur. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

6

Page 6
Image 6
Weber 55014 manual Install Igniter