Weber 55052 0100, Liquid Propane Grill manual Install the work surface, You will need work surface

4.) While holding swing-up work surface in position,	To raise swing-up work surface: Lift table all the way up
insert the other end of the swing-up work surface	and slide it to the right, then lower table until you feel it
rod into the left end trim piece. Push the trim piece	lock in the up position.
into the frame.
	To lower swing-up work surface: Lift table up until it
	disengages and slide it to the left. Then lower it all the
	way down so that the locking pin on the right side of
	the table fits into the locking bracket on the leg, which
	will secure the table in the down position.
	Do not use the swing-up work surface as a cutting
	board.

5.) Add a washer to the bolt and insert it through the hole in the frame and the hole in the trim piece. Tighten with a wrench.

Install the work surface

You will need: work surface.

Place the work surface, so that the front and back edges fit over the frame, in the area between the left trim piece and the cooking box as shown.

Do not use the work surface as a cutting board.

(1)

(1) Make sure that the tabs on the side table are to the right, next to the cooking box.

C-5