Weber 56515 manual Maintenance, m CAUTION Do not enlarge the burner ports when cleaning

Models: 56515

1 64
Download 64 pages 63.14 Kb
Page 19
Image 19
m CAUTION: Do not enlarge the burner ports when cleaning.

MAINTENANCE

Burner Tube Removal

E) To remove burner tube(s):

a) Remove igniter wire(s) from igniter clip(s) (7)..7 b) Remove screw that holds burner tube to the cookbox using a flathead

screwdriver (8)..

c) Pull burner tube assembly (this includes igniter) up and out of cookbox (9).. Note: 310/320 units will have an additional grounding wire attached to the center burner tube (10)..

Burner Tube Cleaning

F)To clean the burner tube(s):

a)Look inside each burner with a flashlight (11)..

b)Clean the inside of the burners with a wire (12) (a straightened-out coat hanger will work)..

c)Check and clean the air shutter opening at the ends of the burners.. Check and

clean the valve orifices at the base of the valves.. Use a steel bristle brush to

9

clean outside of burners (13).. This is to make sure all the burner ports are fully

open..

m CAUTION: Do not enlarge the burner ports when cleaning.

Burner Tube Reinstallation

G) To reinstall burner tubes:

a) Slide burner tube and igniter wire through hole in cookbox (14).. Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper burner position..

b)Align burner tube with valve..

m CAUTION: The burner openings (15) must be positioned properly over the valve orifices (16).

c)Re-install screw that holds the burner tube to the cookbox using a flathead

screwdriver.. Burner tube may seem loose (17), when screw is snug.. This is normal..

d)Route wires back through igniter clips.. Refer back to figure (7)..

m CAUTION: All wires must be properly routed through wire clips.

e) Attach wires to module, following the numerical/color coding (18).. Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper attachment of wires..

mWARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (Refer to “CHECK FOR GAS LEAKS”.)

m WARNING: Make sure that all parts are assembled and hardware is fully tightened before operating the grill. Your actions, if you fail to follow this Product Warning, may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as damage to property.

8

10

11 Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background

12

13

15

14Manual background

16

17

18

WWW.WEBER.COM® 19

Page 19
Image 19
Weber 56515 manual Maintenance, m CAUTION Do not enlarge the burner ports when cleaning