SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as shown on nameplate of the unit to power your blower.
The extension cord used to reach the power source must be:
DSpecifically marked as suitable for out- door use. The cord must be marked with the suffix
DHeavy enough to carry full current from the power source to the unit. Otherwise, loss of power and overheating can oc- cur causing damage to unit. Refer to table for minimum wire gauge recom- mendations. The cord must be marked with the proper wire gauge. (Appropriate extension cords are available.) Do not use multiple cords.
DIn good condition. Cord insulation must be intact with no cracks or deterioration. Plug connectors must be undamaged. DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS | 25 FT. | 50 FT. | 100 FT. | |
|
|
|
| |
120 | 16 | 16 | 14 | |
A.W.G.* | A.W.G.* | A.W.G.* | ||
| ||||
|
|
|
|
*American Wire Gauge
Secure the extension cord to the unit by threading the cord through the cord re- tainer (see illustration). Insert the cord receptacle into the recessed plug.
CAUTION: Failure to use cord retain- er could result in damage to the unit, extension cord, or both.
Cord Receptacle
Recessed Plug on Unit
Cord 
Retainer
USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations to your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
ON/OFF | Top Handle |
| |
Switch |
|
Air Vents
Tube Release Button
Blower Tube
Cord
Retainer
ON/OFF SWITCH
The ON/OFF SWITCH is used to activate the motor.
BLOWER TUBE
The BLOWER TUBE is designed to direct the flow of air.
TUBE RELEASE BUTTON
The TUBE RELEASE BUTTON secures the blower tube or elbow tube to the blower unit during operation. Also, pressing the tube release button allows removal of the blower tube or elbow tube.
5
