ATTACHING THE ACCESSORIES
To attach a Short Handle (67) to a high pulley, first attach the high pulley to the resistance system (see ATTACHING THE HIGH PULLEYS on page 15). Then, attach the Short Handle to the Short Cable (60) with a Cable Clip (64).
The Long Handles (not shown) and the Ankle Strap (not shown) can be attached to the long cable (not shown) with Cable Clips (64). Attach the Leg Press Strap (not shown) to both ends of the long cable, or the Lat Bar (not shown) to the Short Cables (60), with two Cable Clips.
ATTACHING THE LEG LEVER
To use the Leg Lever (32), attach the two ends of the Leg Lever Cable (62) to the ends of the long cable (C) with two Cable Clips (64).
Detach the Leg Lever Cable (62) from the long cable
(C)when the Leg Lever (32) is not in use. Store the ends of the Leg Lever Cable on the hook under the Bench Rail (23).
ADJUSTING THE RESISTANCE
To change the resistance setting, press the + / – switch on the Console (53). The display will show the current resistance setting. The resistance can be increased up to 240 pounds.
Note: While the resistance setting is changing, the motor will be heard. To prevent damage to the motor, do not pull any of the cables while the resistance setting is changing.
Note: The resistance system uses progressive resist- ance. As the resistance bar begins to bend, the amount of resistance will increase gradually. As the bar bends further, the resistance will increase rapidly.
60 |
64 |
67 |
60 |
C |
64 |
62 |
32 |
Hook |
53 |
+ / – Switch |
16
