6.Grease a 3/8” x 4” Bolt (86) using the included grease pack. Attach the Bench Rail (23) to the Upright (3) with the Bolt and a 3/8” Nylon Jamnut (92). Make sure the Bolt is inserted through the indicated hole in the Bench Rail. Do not overtighten the Jamnut; the Bench Rail must be able to pivot easily.
Tighten the Storage Knob (26) into the Upright (3) and the Bench Rail (23).
7.Grease a 3/8” x 2 3/4” Bolt (93). Orient the Leg Lever (32) with the slot on the side shown. Attach the Leg Lever to the Front Leg (31) with the Bolt and a 3/8” Nylon Locknut (73). Do not overtight- en the Locknut; the Leg Lever must be able to pivot easily.
8.Pull out the Seat Knob (43) as far as it will go, and set the Seat Carriage (48) on the Bench Rail (23).
Loosely attach two 8mm Metal Spacers (45), a 60mm Metal Spacer (44), and two Bearing Wheels (46) to the center holes in the Seat Carriage (48) with two M8 Flange Nuts (47) and the M8 x 114mm Axle (102). Make sure that the serrated edge of the Flange Nuts are against the Seat Carriage.
While a second person presses down on the Seat (41), hold the wheel assembly firmly against the bottom of the Bench Rail (23) and properly tight- en the M8 Flange Nuts (47). Make sure that three threads are extending past the Nuts, and that the wide sides of all six Bearing Wheels (46) are pressed against the Bench Rail.
Engage the Seat Knob (not shown) into an adjustment hole in the Bench Rail (23).
6 |
|
|
|
|
|
| 3 |
|
| 26 |
|
73 |
|
|
|
Hole |
| 86 |
|
23 |
|
| |
|
|
| |
|
| Grease | |
7 | 93 |
|
|
|
|
| |
Grease |
|
|
|
32 | Slot | 73 |
|
|
|
| |
|
| 31 |
|
8 |
| 48 |
|
|
|
| |
47 |
|
|
|
|
| 102 |
|
41 |
| 47 |
|
|
| 43 |
|
23 |
|
|
|
|
| 46 |
|
| 45 | 44 | 46 |
|
| ||
|
|
| 45 |
| Wide |
|
|
| Side |
|
|
9
