Weider 831.15711.0 Do not tighten the Nylon Locknuts yet, Tighten the Nylon Locknuts yet

2. Attach the Bench Frame (1) to the Front Leg (2)	2
with two M10 x 65mm Bolts (40), two M10
Washers (44), and two M10 Nylon Locknuts (43).				40
Do not tighten the Nylon Locknuts yet.
								1
		44
					40
	43
				2
3. Attach the Bench Frame (1) to the Crossbar (4)	3
with two M10 x 81mm Bolts (41) and two M10
Nylon Locknuts (43).					4
Tighten the M10 Nylon Locknuts (43) used in								43
steps 1 through 3.				41
				1	41
4. Attach the Weight Tube (16) inside the Leg Lever	4
(3) with an M8 x 58mm Bolt (52), two M8
Washers (56), a 10mm Spacer (32), and an M8					43	2
Nylon Locknut (55).
				3
Press the 25mm Round Angled Cap (28) onto the								Grease
Weight Tube (16).
		55
				32		28		54
Grease an M10 x 68mm Bolt (54). Attach the Leg
		56
Lever (3) with the Bolt and an M10 Nylon Locknut
(43). Do not overtighten the Nylon Locknut;
the Leg Lever must pivot easily.		16		56	52
5. Orient the Backrest Frames (12) with the indicat-	5
ed tubes in the position shown. Attach the			49		48		12
Backrest Frames to the Backrest Bracket (10)
with four M6 x 40mm Bolts (49), four M6 Washers
(48), and four M6 Nylon Locknuts (51). Do not				48				12
tighten the Nylon Locknuts yet.								48
		Tubes					48	49
					51
				10			51

7