To Change Parental Lock Settings

Changing the Parental Lock settings follows the same procedure, except that you must first enter your 4-digit password before making any changes on the Parental Lock sub-menu.

If you enter the wrong password, you can- not proceed. If you enter it wrong more than three times, the cursor jumps to EXIT field.

NOTE: If you forget your password, enter the master password “8888”.

Playback with Parental Lock

P1-D

When you play a disc that has a rating less than or equal to your specified Level, playback proceeds normally. If you attempt to play a disc that is rated above your specified Level, the following display appears on the TV screen asking if you want to temporarily override the Parental Lock and play the disc:

1.To eject the disc, use the CURSOR buttons on Page 1 of the remote to high- light the NOT RELEASE field, then press the OK button. Eject the disc.

2.To play the disc, use the CURSOR buttons to highlight the TEMPORARY RE- LEASE field, then press the OK button.

3.Enter the 4-digit password using the NU- MERIC buttons on Page 4 of the remote. If you enter the wrong password three times, playback is prohibited. If you enter the cor- rect password, the parental lock is tempo- rarily removed and playback begins.

Specifications

Amplifier

Output Power, Stereo Operation:

80 W per ch, min. RMS, 8 ohms, 40 Hz – 20 kHz with no more than 0.8% total harmonic distortion.

Output Power, Surround operation:

80 W per ch, min. RMS, 8 ohms at 1 kHz, with no more than 0.8% total harmonic distortion.

Audio

Audio Input Sensitivity/Impedance (1 kHz):

TV, TAPE/CDR, STB, VCR: 240 mV/47 kOhm

Audio Input (DIGITAL IN):

Coaxial: 0.5 V(p-p)/75 ohms

Optical: –21 dBm to –15 dBm (660 nm ±30 nm)

Digital formats:

Linear PCM, Dolby Digital, and DTS (with sampling frequency–32 kHz, 44.1 kHz, 48 kHz)

Signal-to-Noise Ratio (’66 IHF/’78 IHF):

TV, TAPE/CDR, STB, VCR: 87 dB/67 dB

Frequency Response:

TV, TAPE/CDR, STB, VCR: 20 Hz to 20 kHz (±1 dB)

Tone Control:

Bass (100 Hz): ±10 dB

Treble (10 kHz): ±10 dB

Video

Video Input Sensitivity/Impedance (1 kHz): Composite video: 1 V(p-p)/75 ohm

S-Video: (Y: luminance): 1 V(p-p)/75 ohm

S-Video: (C: chrominance): 0.286 V(p-p)/75 ohm

RGB video: 0.7 V(p-p)/75 ohm

Video Output Level/Impedance (1 kHz): Composite video:1 V(p-p)/75 ohm

S-video (Y:luminance): 1 V(p-p)/75 ohm

S-video (C:chrominance): 0.286 V(p-p)/75 ohm

RGB video: 0.7 V(p-p)/75 ohm

Color System:

PAL

Horizontal Resolution: 500 lines or more

Signal-to-Noise Ratio (S/N):

63 dB

Synchronize:

Negative

FM tuner (IHF)

Tuning Range:

87.5 MHz to 108.0 MHz

AM tuner

General

Power Requirements:

AC 230 V, 50 Hz

Power Consumption:

180 W

2 W (in standby mode)

Dimensions (W x H x D):

435 mm x 118 mm x 415 mm

(17 3/16 in. x 4 5/8 in. x 16 3/8 in.)

Weight:

9.7 kg (21.4 lbs)

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.

Tuning Range:

522 kHz to 1629 kHz

Page 38
Image 38
Rotel RSDX-02e owner manual Specifications