ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure that the weight bench can be assembled suc- cessfully by almost anyone. By setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two persons.
•Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Assembly requires the included hex key(s) 
and the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a socket set, a set of
1. | 1 |
|
Before beginning assembly, make sure |
| |
that you have read and understand the |
|
|
information in the box above. See the | 4 |
|
PART IDENTIFICATION CHART on page 5 |
| |
|
| |
for help identifying small parts. | 42 |
|
|
| |
|
| 42 |
Orient the Front Stabilizer (2) so that the square |
|
|
holes are toward the floor. Attach the Front |
| 2 |
Stabilizer to the Front Leg (4) with two M10 x |
| |
90mm Carriage Bolts (43) and two M10 Nylon | Square |
|
Locknuts (42). Do not tighten the Nylon |
| |
Holes |
| |
Locknuts yet. |
| |
|
| |
| 43 |
|
2. Orient the Rear Stabilizer (3) so that the square | 2 |
|
holes are on the side shown. Attach the Rear |
| |
|
| |
Stabilizer to the Frame (1) with two M10 x | 3 | Square |
90mm Carriage Bolts (43) and two M10 Nylon | 42 | Holes |
Locknuts (42). Do not tighten the Nylon |
| 43 |
Locknuts yet. |
| |
|
| |
| 1 |
|
| 42 |
|
| 6 |
|
