ASSEMBLY
Make Assembly Easier
This manual is designed to ensure that the inversion system can be assembled successfully by almost anyone. Most people find that if they set aside plenty of time, assembly goes smoothly.
Before beginning assembly, carefully read the following information and instructions:
•To hire an authorized service technician to assemble the inversion system in your home, call
•Assembly requires two persons.
•Because of its weight and size, the inversion sys- tem should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the inversion system as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•For help identifying small parts, see the PART IDENTIFICATION CHART on page 5.
•As you assemble the inversion system, make sure that all parts are oriented as shown in the draw- ings.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•Assembly requires the following tools:
the included hex key(s) two adjustable wrenches
one rubber mallet
one standard screwdriver 
one Phillips screwdriver 
Assembly will be more convenient if you have a
socket set, a set of
1.Before beginning assembly, make sure that you understand the information in the box above.
Open the Front and Rear Legs (1, 2, 3), and push down on the Link Bars (10, 11, 12) so that they are straight across as shown.
1 |
|
|
|
|
|
| 10 | 12 | 3 |
|
|
|
|
|
| ||
|
|
|
| 3 | |
1 |
|
| 11 | 12 | |
|
|
|
|
| |
|
| 2 |
|
|
|
6 |
|
|
|
|
|
