10.Attach the Backrest (15) to the Backrest Tubes (20) using four M6 x 38mm Screws (14) and four M6 Flat Washers (51).
Make sure that the Backrest (15) is oriented so that there is a gap between the Backrest and the Seat (16).
11.Press a 1Ó Round Inner Cap (21) into the weight tube of the Weight Carriage (12). Slide a Weight Stop (34) onto the weight tube. Press a 2 1/2Ó Square Bushing (23) onto each end of the Weight Carriage (12).
Slide an M10 x 19mm Bolt (44) into the bracket on the Weight Carriage (12). Slide the Weight Carriage onto the Lat Tower (11).
Thread the Cable (25) through the slot of the Lat Tower (11) in the direction indicated. Connect the end of the Cable without the ball to the Weight Carriage (12) using the M10 x 19mm Bolt (44) and an M10 Nylon Locknut (45).
12.Press a 45mm Square Inner Cap (28) into the top of the Lat Tower (11). Route the Cable (25) around the Pulley (26) as indicated. Slide the Pulley into the slot of the Lat Tower and attach it with an M10 x 64mm Bolt (46), two M10 Flat Washers (54), two M10 Spacers (42), and an M10 Nylon Locknut (45).
Do not overtighten the Nylon Locknut. The Pulley must be able to turn freely. Attach the Cable Clip (35) to the end of the Cable.
13.Slide the Lat Tower (11) into the Front Leg (2). Tighten it in place with the Short Adjustment Knob (27).
9
10 |
|
|
|
|
15 |
|
|
|
|
16 |
|
|
|
|
|
|
| 14 | 51 |
|
|
| 20 |
|
|
|
| 51 |
|
| 14 |
|
|
|
11 |
|
|
|
|
| Slot |
|
|
|
|
|
|
| Ball |
|
|
| 11 | |
Weight | 25 | 23 | ||
|
| |||
Tube | 45 |
|
| 44 |
|
| Bracket | ||
|
|
| ||
21 |
|
| 12 | |
|
|
| ||
34 |
|
| 23 | |
|
|
| ||
12 |
|
| 28 |
|
| 54 | 42 |
| |
|
|
| ||
45 |
| 42 |
| |
|
|
|
| |
26 |
|
|
| 54 |
|
|
|
| |
|
|
|
| 46 |
| 11 |
| 25 | |
|
|
| ||
|
|
|
| 35 |
13 |
|
|
|
|
|
|
| 27 |
|
| 11 |
|
|
|
| 2 |
|
|
|
