![](/images/new-backgrounds/1246696/24669625x1.webp)
24. Route the Cable (79) through the Lat Tower Base | 24 |
|
|
(49) and under an 89mm Pulley (65). Attach the |
|
| |
|
| 32 65 | |
Pulley to the bracket on the Lat Tower Base with |
|
| |
an M10 x 45mm Bolt (27) and an M10 Nylon |
|
| 27 |
Locknut (32). |
|
| |
| 79 |
|
|
|
|
| 49 |
25. Route the Cable (79) under an 89mm Pulley (65) | 25 |
|
|
and through the Foot Plate (57) as shown. Attach |
| 74 | |
43 |
| ||
the Pulley to the Foot Plate with an M10 x 45mm |
| 32 | |
Bolt (27) and an M10 Nylon Locknut (32). |
|
| 74 |
| 27 |
| |
Attach the Foot Plate (57) to the Lat Tower Base |
| 32 | |
|
| ||
(49) with two M10 x 19mm Bolts (72) and two |
|
| 65 |
|
| 32 | |
M10 Nylon Locknuts (32). |
|
| |
|
|
| 32 |
Attach the Foot Plate (57) to the Front Crossbar | 18 |
|
|
(43) with two M10 x 94mm Bolts (18), two M10 |
| 32 | |
79 |
| ||
Washers (74), and two M10 Nylon Locknuts (32). |
| 49 | |
|
|
| |
Tighten all of the M10 Nylon Locknuts (32) | 72 |
|
|
used in steps |
| 57 | |
|
| ||
26. Press two 48mm Round Inner Caps (23) into two | 26 |
|
|
Storage Tubes (70). Screw the Storage Tubes |
|
|
|
onto the Left Rear Upright (46). Make sure the |
|
|
|
Storage Tubes are fully tightened. |
|
| 70 |
|
|
| |
Repeat this step with the other two Storage |
|
| 23 |
|
| 46 | |
Tubes (70) and the Right Rear Upright (not |
|
| |
|
|
| |
shown). |
|
| 70 |
|
|
| |
|
|
| 23 |
27. Press two 32mm Round Inner Caps (68) into the | 27 |
|
|
ends of the Left Weight Rest (80) and the Left |
|
| |
|
|
| |
Safety Spotter (81). |
| 68 | |
| 80 | ||
Insert the Left Weight Rest (80) and the Left |
|
| |
|
|
| |
Safety Spotter (81) into holes in the left Front |
|
| 44 |
Upright (44) and engage the locking pins around |
| 68 | |
81 |
| ||
the Upright. |
|
| |
Repeat this step with the Right Weight Rest |
|
|
|
(not shown), the Right Safety Spotter (not |
|
|
|
shown), and the right Front Upright (not |
|
|
|
shown). |
|
|
|
| 13 |
|
|