ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
•Place all parts of the home gym in a cleared area and remove the packing materials; do not dis- pose of the packing materials until assembly is completed.
•Assembly is divided into four stages: 1) frame assembly, 2) press and butterfly arm assembly, 3) cable and pulley assembly, and 4) seat and back- rest assembly. The hardware for each stage is packaged separately.
•Wait until you begin each assembly stage to open that parts bag.
•For help identifying the small parts used in assembly, use the PART IDENTIFICATION
CHART located in the center of this manual. Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been
•As you assemble the home gym, be sure that all parts are oriented as shown in the drawings.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:
•Two (2) adjustable wrenches 
•One (1) standard screwdriver 
•One (1) Phillips screwdriver 
•One (1) rubber mallet 
•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.
Assembly will be more convenient if you have the following tools: A socket set, a set of
FRAME ASSEMBLY
1.Before beginning assembly, be sure that you have read and understand the infor- mation in the box above.
Press a 2” Square Outer Cap (51) onto each end of the Stabilizer (5). Press a 2” Square Inner Cap (27) into the end of the Base (4).
Insert two 5/16” x 2 3/4” Carriage Bolts (14) up through the Stabilizer (5). Insert two 5/16” x 2 1/2” Carriage Bolts (1) up through the Base (4).
Slide the bracket end of the Base (4) onto the 5/16” x 2 3/4” Carriage Bolts (14) in the Stabilizer (5). Slide the Rear Upright (56) onto the Carriage Bolts. Hand tighten a 5/16” Nylon Locknut (3) onto each Carriage Bolt.
1
56
3
51 |
5
4
51 14
127
5
