Weider WESY16010 user manual Cable Assembly

CABLE ASSEMBLY

12.Route the Long Cable (58) around a “V”- Pulley (6). Be sure that the Cable is in the groove of the “V”-Pulley and that a Long Cable Trap (50) is turned to hold the Cable in place.

Attach the “V”-Pulley (6) and the Long Cable Trap (50) to the Right Arm (48) with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21).

Make sure the Bolt and Nylon Locknut are tight.

13.Refer to the inset drawing. Using a 5/16” x 4 3/4” Bolt (64) and a 5/16” Nylon Locknut (3), attach the Pulley Bracket (20) to the indi- cated bracket on the Top Frame (55). Note:

The Pulley Bracket is pre-assembled with a 3 1/2” Pulley (15) and a Cable Trap (66).

Route the Long Cable (58) around the 3 1/2” Pulley (15) attached to the Pulley Bracket (20). Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. Make sure that the 3/8” x 2” Bolt (12), securing the Pulley and Cable Trap to the Pulley Bracket, is properly tightened and that the Pulley Bracket can pivot freely.

14.Locate the Long “U”-Bracket (57) that is pre- assembled with a 3 1/2” Pulley (15) and a Cable Trap (not shown). Route the Long Cable (58) around the Pulley and through the Long “U”-Bracket. Be sure that the Cable is in the groove of the Pulley, that the Cable Trap is turned to hold the Cable in place, and that the Cable and Pulley move smoothly.

15.Route the Long Cable (58) around a 3 1/2” Pulley (15). Using a 3/8” x 1 3/4” Bolt (71) and a 3/8” Nylon Locknut (21), secure the Pulley to the indicated bracket on the Top Frame (55). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

9

12			50		7
					6
				48	21
	58
13			66
20
15				12
		58
					55
					64
					66
					20
					3
14
		15	58
			57
15		55		58	15
					71
			Bracket
			21