ARM ASSEMBLY
5.Press a 1 3/4” Square Inner Cap (44) into the top of one of the Press Arms (46). Press a 1” Round Inner Cap (49) into each end of the handle on the Press Arm. Attach the Press Arm to one side of the Press Frame (17) with two 5/16” x 2 1/2” Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same manner.
6.Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 7.
7.Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 6 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).
Tap two 1” Retainers (63) and a 1” Round Cover Cap (62) onto the right axle. Be sure that the teeth on the Retainers bend toward the Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a Foam Pad (45) onto the lower end of each Arm.
5 |
| 44 |
|
| |
|
| 49 |
44 |
|
|
| 49 | 46 |
49 |
| |
|
| |
46 | 22 |
|
|
| 3 |
|
| 17 |
6 |
|
|
Welded |
| 47 |
Brackets |
| |
48 |
|
|
7 | 55 |
|
| 47 | |
|
| |
| Bracket | |
| Lubricate | |
| Axle | |
48 | 63 |
|
|
| |
| 62 | 45 |
44 |
|
|
45 |
| 55 |
|
| |
|
| 63 |
|
| 62 |
7
