1.
Frame Assembly
Before beginning assembly, make sure you understand the information in the box on page 5. Refer to the PART IDENTIFICATION CHART in the center of this manual for help identifying small parts.
1 |
1 |
78 |
Insert four M8 x 63mm Carriage Bolts (78) up through the Base (1). Note: It may be helpful to place a piece of tape over the bolt heads to hold them in place.
2.Attach the Base (1) and the two Weight Guides (21) to the Stabilizer (2) with two M10 x 67mm Bolts (71), two M10 Washers (57), and two M10 Nylon Locknuts (56). Make sure the indicated holes in the Weight Guides are nearer the bot- tom. Fully tighten the Locknuts.
Attach the Upright (3) to the Base (1) with the indicated two M8 x 63mm Carriage Bolts (78) and two M8 Nylon Locknuts (58). Do not tighten the
Locknuts yet.
| 78 |
|
2 |
|
|
| Holes | |
| 21 |
|
| 21 |
|
3 |
|
|
| 57 | 56 |
58 | 71 | 57 |
58 |
|
|
| 71 | 2 |
1 |
| |
|
| |
78 |
|
|
6
