Weider WESY3873.2 user manual

12.Insert the rod on the Backrest Frame (15) into the slot in the Seat Carriage (12). Hold the Backrest

Frame vertically over the Seat Carriage and slide the rod into the slot, as shown in the inset drawing.

13.Attach the two 10-pound Short Caps (20) to the 10-pound Center Resistance Bar (44) with two M4 x 12mm Flat Head Screws (85).

Using ten M4 x 12mm Flat Head Screws (85), attach the two 10-pound Caps (32) to the 10- pound Removable Resistance Bar (67), the two 20-pound Caps (77) to the 20-pound Removable Resistance Bar (36), the four 80-pound Caps (33) to the two 80-pound Resistance Bars (55), and the two 40-pound Caps (79) to the 40-pound Resistance Bar (52).

14.Locate the Fulcrum (18) on the Top Upright (4) (see the inset drawing). Slide the Tray (35) onto the rods on the Fulcrum. Make sure the Tray is oriented as shown in the drawing.

Set the Resistance Bars into the Tray (35) in the following order: the 10-pound Removable Resistance Bar (67), the 20-pound Removable Resistance Bar (36), an 80-pound Resistance Bar (55), the 10-pound Center Resistance Bar (44), the other 80-pound Resistance Bar (55), and the 40-pound Resistance Bar (52). Make sure the indicated rings are on the side shown and the arrows point toward the Tray.

Attach the Cover Plate (72), with the edges up, to the Tray(35) with two M8 x 19mm Button Head Screws (86).

12
15
12		15
		Rod
				Slot
				12
13
		55	52
36				79
				85
67
44			85	33
		85
	85		77
85	20	32
14		86
72			Edges
55
			up
				52
Rings on			44
this side
35
18				55
				36
4		Rods	67
18

9