35.Attach a Pulley (43) inside the Curl Post Upright (10), above the Low Cable (70), with an M10 x 65mm Bolt (87), two M10 Washers (108), two 1/2” Bushings (68), and an M10 Nylon Locknut (84).
36.Route the Low Cable (70) through the Right Seat Upright (11) and the Right Upright (7) and under a Pulley (43). Attach the Pulley, an M10 Washer (108), and two Half Guards (46) to the Right Base
(1) with an M10 x 45mm Bolt (95) and an M10 Nylon Locknut (84). Make sure the Half Guards are oriented as shown.
37.Wrap the Low Cable (70) over a Pulley (43). Attach the Pulley, a Cable Trap (48), and two Half Guards (46) at the second hole from the bottom of the two Pulley Plates (49) with an M10 x 50mm Bolt (105) and an M10 Nylon Locknut (84). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Make sure the Half Guards are oriented as shown.
35 |
|
|
|
|
| 10 | |
84 | 68 | 43 | 70 |
|
|
| |
108 |
|
|
|
|
|
| 68 |
|
|
| 108 87 |
36 |
|
|
|
|
| 70 | |
84 | 7 |
|
|
| 43 |
| |
46 | 108 |
|
|
11 |
|
|
|
| 1 | 46 | 95 |
|
| ||
37 |
|
|
|
84 |
|
| 49 |
46 |
| 46 | |
| 48 |
| 105 |
| 43 |
| |
|
|
| |
|
|
| 70 |
18 |
|
|
|
