1.
Frame Assembly
Before beginning assembly, make sure you understand the information in the box on the previous page. For help identifying small parts, use the PART IDENTIFICATION CHART on pages 5 and 6 of this manual.
1 |
1 |
88 |
2 |
88 |
Insert four M10 x 80mm Carriage Bolts (88) up through the Right Base (1). Place a piece of tape over the Bolt heads to hold the Carriage Bolts in place.
See the inset drawing. Insert two M10 x 80mm Carriage Bolts (88) up through the Left Base (2). Place a piece of tape over the Bolt heads to hold the Carriage Bolts in place.
2.Attach the Center Base (5) to the Right and Left Bases (1, 2) with four M10 x 70mm Bolts (57), four M10 Washers (108), and two M10 Nylon Locknuts (84). Do not tighten the Bolts yet.
3.Orient the Center Upright (9) so the 2" Square Inner Cap (51) is in the position shown. Attach the Center Upright to the Right and Left Bases (1, 2) with four M10 x 70mm Bolts (57), four M10 Washers (108), and two M10 Nylon Locknuts (84). Do not tighten the Bolts yet.
|
| 88 |
|
2 | 84 | 84 |
|
|
| ||
|
|
| |
|
| 5 |
|
| 57 |
| 57 |
| 108 |
| 108 |
|
|
| |
| 1 |
| 2 |
3 | 51 |
|
|
|
|
| |
| 9 |
|
|
| 57 | 108 | 57 |
|
|
| |
| 108 |
| 108 |
| 84 |
| 84 |
|
|
| |
| 1 |
| 2 |
|
|
|
8
