38.Wrap the Low Cable (70) under a Pulley (43). Attach the Pulley, an M10 Washer (108), and two Half Guards (46) to the Right Base (1) with an M10 x 45mm Bolt (95) and an M10 Nylon Locknut (84). Make sure the Half Guards are oriented as shown.
39.Route the Low Cable (70) over a Pulley (43) and through the Center Upright (9). Attach the Pulley inside the Center Upright with an M10 x 65mm Bolt (87), two M10 Washers (108), two 1/2” Bushings (68), and an M10 Nylon Locknut (84).
40.Wrap the Low Cable (70) under a Pulley (43). Attach the Pulley, a Cable Trap (48), and a Guard (45) to the Small Pulley Plate (50) with an M10 x 50mm Bolt (105) and an M10 Nylon Locknut (84).
Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
41.Wrap the Low Cable (70) over a Pulley (43). Attach the Pulley to the Left Top Frame (4) with an M10 x 45mm Bolt (95) and an M10 Nylon Locknut (84).
38 |
|
| 70 |
|
|
| |
| 84 |
|
|
| 46 | 108 | 43 |
|
|
| |
|
| 1 |
|
|
| 46 | 95 |
39 | 84 108 |
| |
|
| ||
| 68 |
| 108 |
|
|
| |
| 43 |
|
|
| 70 | 68 |
|
|
| 87 | |
|
| 9 | |
|
|
| |
40 |
|
|
|
|
| 70 | 84 |
|
|
| 48 45 |
|
|
| 43 |
|
| 105 50 |
|
41 |
|
|
|
|
| 4 |
|
|
| 84 |
|
|
| 43 |
|
|
| 70 | 95 |
|
|
| |
19
