39.Route the Leg Lever Cable (75) under a 4 1/2” Pulley (119). Attach the Pulley and a Large Cable Trap (121) to the indicated side of the Butterfly Upright (3) with a 3/8” x 3 3/4” Bolt (122), a 3/8” Washer (91), and a 3/8” Nylon Jamnut (113). Make sure that the Large Cable Trap is turned to hold the Cable in the groove of the Pulley.
40.Wrap the Leg Lever Cable (75) over a 3 1/2” Pulley
(78).Attach the Pulley to the Double
(62)with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
41.Remove the preattached 3 1/2” Pulley (not shown) from the
Attach the end of the Leg Lever Cable (75) to the
42.Locate the Swivel Low Cable (72), which is the only remaining cable that has an eyelet on one end and a ball on the other end. Route the eyelet end of the Cable through the cage on the Long Base (120) and through the Swivel Upright (5), as shown.
Attach a 3 1/2” Pulley (78) to the indicated bracket on the Long Base (120) with 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
43.Wrap the Swivel Low Cable (72) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated brack- et on the Long Base (120) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
16
39 |
|
|
| 119 |
|
122 |
|
|
121 |
|
|
| 3 |
|
| 75 |
|
| 91 | 113 |
40 |
|
|
| 93 |
|
| 62 |
|
| 87 |
|
| 75 |
|
| 78 |
|
41 |
|
|
| 75 |
|
| 64 |
|
| 97 |
|
| 34 |
|
42 |
|
|
78 |
|
|
72 |
|
|
Cage | 87 |
|
|
| |
120 | 5 |
|
93 |
| |
43 |
|
|
| 72 |
|
78 |
|
|
120 | 87 |
|
93 |
| |
|
|
