![](/images/new-backgrounds/1183416/18341635x1.webp)
49.Wrap the Swivel Low Cable (72) over a 3 1/2” Pulley (78). Attach the Pulley and a Cable Trap (68) between the lower set of holes in the
50.Attach the end of the Swivel Low Cable (72) inside of the Short Base (2) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).
51.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (120) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).
52.Wrap the Squat Cable (73) over a 3 1/2” Pulley
(78).Attach the Pulley, a Cable Trap (68), and two 3/4” Spacers (124) between the indicated brackets on the Squat Slider (38) with a 3/8” x 3 1/4” Bolt
(96)and a 3/8” Nylon Jamnut (113). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.
18
49 |
|
|
100 |
| 64 |
68 |
| |
| 87 | |
72 |
| |
| 78 | |
|
| |
50 |
|
|
86 90 |
|
|
72 | 90 | 59 |
2 |
|
|
51 |
|
|
| 73 | |
|
| 86 |
|
| 90 |
|
| 120 |
90 |
|
|
59 |
|
|
52 |
|
|
68 124 |
| |
78 |
| 113 |
124 |
| |
|
| |
|
| 38 |
| 96 |
|
73 |
|