SEAT ASSEMBLY
DECAL
47.Press two 3/4Ó Round Inner Caps (34) into each Pad Tube (28).
Insert a Pad Tube (28) into the Front Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg Lever (29). Slide a Foam Foam Pad (30) onto each end of the Pad Tube.
48.Remove the backing from the CLUB WEIDER 16.6ST decal and apply it to the home gym system where shown.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE HOME GYM SYSTEM, beginning on page 22 of this manual.
Before using the home gym system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See
47 |
36 |
30 |
34 |
28 |
34 |
30 |
29 |
48 |
CLUB WEIDER 16.6ST |
21
