Weider WESY49202 user manual ARM Assembly Cable Assembly

ARM ASSEMBLY

CABLE ASSEMBLY

17.Attach the Left Pull-up Arm (75) and the Right Pull-up Arm (77) to the Assist Upright (74) with two M8 x 70mm Bolts (11) and two M8 Nylon Locknuts (3).

Attach the Left Dip Arm (78) and the Right Dip Arm (79) to the Assist Upright (74) with two M8 x70mm Bolts (11) and two M8 Nylon Locknuts (3).

Wet the end of the Left Pull-up Arm (75) with soapy water. Slide a Long Handgrip (80) onto the Left Pull-up Arm.

Slide a Long Handgrip onto the Right Pull-up Arm (77) in the same manner. Slide a Short Handgrip (102) onto the Left Dip Arm (78), and onto the Right Dip Arm (79) in the same manner.

Press four 32mm Round Inner Caps (109) into the Left and Right Pull-up Arms (75, 77).

Press two 32mm Round Inner Caps (109) into the Left and Right Dip Arms (78, 79).

18.Locate and open the pulley bag and the parts bags labeled “CABLE ASSEMBLY.”

During steps 19 through 39, refer to the CABLE DIAGRAMS on pages 26–27 of this manual to verify proper cable routing. Before beginning this section, fully unwind the four Cables. Identify the four Cables by comparing the lengths and ends of the Cables. The approximate length of each Cable is listed after the key number in the drawing.

IMPORTANT: While assembling the cables, do not overtighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely.

19.Locate the High Cable (58). Wrap the High Cable around a 90mm Pulley (15). Attach the Pulley to the Top Frame (55) with an M10 x 95mm Bolt (88) and an M10 Nylon Locknut (21). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the hook.

11

17
	75		74
	80
		11	3
109	109
			77
	109
		11	3
			80
	78		109
	102		3
		102
	109		79
		109
18
			23—75.5”
			58—148”
			72—190”
			99—64”
19
	21	58
	55
	Hook 15	88
	Ball