Weider WESY49202 user manual ARM Assembly, That the pulleys are on the side shown

FRAME ASSEMBLY

ARM ASSEMBLY

9.	Attach the upper ends of the Short Weight	9	61		61
	Guides (73) to the Top Frame (55) with an M8 x			3
	150mm Bolt (60), two 19.5mm Spacers (61),					3
	and an M8 Nylon Locknut (3).	60				55
	Attach the upper ends of the Long Weight
	Guides (62) to the Top Frame (55) in the same
	manner.	73		60
				62
10.	Locate and open the parts bag labeled
	“ARM ASSEMBLY.”
	Make sure there is a Bushing (98) in each side
	of the Stabilizer (5). Press three 50mm Square	10			95	27
	Inner Capa (27) into the ends of the Leg Press
	Arm (96).					Welded
	Lubricate an M10 x 80mm Bolt (67). Attach the					Tube
	Leg Press Arm (96) to the Stabilizer (5) with the					97
	Bolt and an M10 Nylon Locknut (21). Do not			96
	overtighten the Nylon Locknut; the Leg Press
					21	27
	Arm must be able to pivot freely.
	Align the welded tubes on the Leg Press Plate					Lubricate
				98
	(95) with a set of holes in the Leg Press Arm
					27
	(96). Attach the Leg Press Plate to the Leg					67
	Press Arm with the Press Pin (97).				98
					5
11.	Press a 22mm Plastic Bushing (90) onto each	11
	welded spacer on the Press Frame (17). Slide					Pulleys
	the Press Frame into place onto the Base (4).				17	must be on
	Note: This will be a tight fit; the Plastic					this side
	Bushings should fit snugly over the ends of
	the indicated tube in the Base. Make sure				Lubricate
	that the pulleys are on the side shown.
	Lubricate the M10 x 198mm Bolt (59). Attach					59
	the Press Frame (17) to the Base (4) with the			21	Welded Spacers
	Bolt and an M10 Nylon Locknut (21). Do not
	overtighten the Locknut; the Press Frame	4
	must be able to pivot easily.	Tube			90

8