Weider WESY5983.3 user manual Arm 22. Make sure the Cable is on the indicat

19. Wrap the Long Cable (80) under a 90mm Pulley	19
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with an M10 x		3
113mm Button Head Bolt (40) and an M10 Nylon
Locknut (76). Make sure the flat edge of the					28
Pulley Guard is on the bottom.
	40				76
					29
					80
					Flat
					Edge
20. Attach a Pulley Housing (94) to the indicated “U”-	20
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 102mm Bolt (24), two Pivot		44
Bushings (74), and an M10 Nylon Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley		74			74
(28). Attach the Pulley inside of the Pulley		94			76
Housing (94) with an M10 x 42mm Button Head	24				76
Bolt (71) and an M10 Nylon Locknut (76).
		71
					28
					80
21. Wrap the Long Cable (80) around a 90mm Pulley	21
(28). Attach the Pulley and a Pulley Guard (29) to
		28
the indicated M10 x 140mm Carriage Bolt (73)					29
with an M10 Nylon Locknut (76). Make sure the
flat edge of the Pulley Guard is on the side
shown.	80				76
		Flat
22. Make sure there are no Resistance Bars (not		Edge
				73
shown) under the “U”-channels on the 10-pound
Center Resistance Bar (not shown). Have a sec-
ond person pull on the Long Cable (80) to create
slack in the Cable.	22
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross					71
Tube (11) and then through the remaining Swivel
			22		107
Arm (22). Make sure the Cable is on the indicat-		Rod
ed side of the welded rod in the Swivel Arm.
	80
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm		28	76		11
with an M4 x 5mm Screw (107).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
	11