Weider WESY5983.3 user manual Adjusting the Backrest, Storing the Resistance System

ADJUSTING THE BACKREST

The Backrest (14) can be used in a level position or one of three inclined positions. To use the Backrest in a level position, secure the Seat Carriage (12) at the hole in the Bench Rail (5) closest to the Leg Developer (19) (see ADJUSTING THE SEAT on page 13).

To use the Backrest (14) in an inclined position, secure the Seat Frame (12) at one of the three adjustment holes on the Upright (3) side of the Bench Rail (5). Rest the Backrest against the Upright (3).

For row exercises and for using the Leg Lever (7), remove the Backrest (14) from the Seat Carriage (12). Hold the Backrest vertically over the Seat (13) and lift the rod out of the slot in the Seat Carriage (see the inset drawing). To use the Leg Lever (7), secure the Seat Carriage (12) at the second hole from the Leg Developer.

STORING THE RESISTANCE SYSTEM

To store the resistance system, slide the ends of the Leg Lever Cable (32) onto the Hook (104). Make sure the Seat (13) is in the position closest to the Front Leg (6) (see ADJUSTING THE SEAT on page 13). Next, remove the Storage Knob (30) from the Upright

(3). Lift the Front Leg toward the Top Frame (10), and tighten the Storage Knob into the side of the Upright and the Bench Rail. Remove all of the resistance bars from the “U”-channels on the 10-pound Center Resistance Bar (44) (see ADJUSTING THE RESISTANCE on page 14). Finally, loosen the Fulcrum Knob (43) and pull it out as far as it will go. Turn the resistance assembly vertically and engage the Fulcrum Knob into the fulcrum on the Lat Tower

(4). Note: Storing the resistance bars vertically will prolong the life of the resistance bars.

To move the resistance system, place the toe of your shoe on the end of the Base (1) and hold the resist- ance system in the indicated area. Tilt the resistance system back onto the Wheels (31) and roll it to the new location. Be careful not to let the Front Leg (6) or Leg Lever (7) pinch your hands when you tilt the system back.

WARNING: Make sure that all of the resistance bars are removed from the “U”- channels before moving the resistance assem- bly to the stored position.

Make sure that the resistance assembly is in the horizontal position and that the Storage Knob (30) is in place and fully tightened each time the resistance system is used.

Rod
15	3
	Slot
	12
13
	14
19
7	5
	12
Resistance	10
Bar
	4
“U”-Channel	“U”-Channel
	44
	43
	3
	80
	30
13
6	31
7
	1
32	Stored Position
	Hold in
	this area
	104

15