6.Pull the Seat Knob (45, not shown) out as far as it will go, and slide the Seat Carriage (12) onto the Bench Rail (5). Engage the Seat Knob into the third hole from the end of the Bench Rail.
See the inset drawing. Attach a Hook (104) to the bottom of the Bench Rail (5).
Press the two Rail Inner Caps (99), with the wide ends on the top or bottom (as indicated), into the ends of the Bench Rail (5). Attach the Caps with four M4 x 16mm Screws (62).
Locate the Leg Lever Cable (32), which has three ends connected in the middle with a bracket. Route the end of the Cable with the eyebolt under a
7.Attach the Bench Rail (5) to the Upright (3) with an M10 x 132mm Bolt (66), a 19mm Spacer (17), a 22mm Spacer (106), and an M10 Nylon Locknut (76). Fully tighten the Storage Knob (30) into the Upright and the Bench Rail.
8.Attach the Lat Tower (4) to the Upright (3) with four M10 x 25mm Button Head Screws (87) and four M10 Split Washers (103).
Attach the Name Plate (89) to the Lat Tower (4) with two M4 x 16mm Screws (62).
6 |
| Third |
|
|
| Hole |
|
45 |
|
|
|
|
| 5 |
|
62 |
|
|
|
99 |
| 12 |
|
Wide | 62 |
| |
|
| ||
End | 92 | 32 |
|
6 |
|
|
|
76 |
| 99 | Wide |
Eyebolt | 97 | 62 | End |
| |||
| 5 |
| |
|
|
| |
|
|
| 62 |
|
|
| 104 |
7 | 30 |
| |
|
| ||
| 76 | 3 |
|
|
|
| |
17 |
|
| 66 |
5 |
|
| |
|
|
| |
| 106 |
| |
8 |
|
|
|
|
| 4 |
|
|
| 103 87 |
|
62 |
| 87 |
|
89 |
|
|
|
62 |
| 103 |
|
|
|
| |
3 |
|
|
|
7
