12. Press two 25mm Square Inner Caps (54) into the | 12 |
|
| |
indicated end of the Backrest Frame (15). |
|
| ||
|
|
| ||
Attach a Plastic Foot (53) to the Backrest Frame | 14 |
|
| |
(15) with an M4 x 16mm Screw (62). |
|
| ||
|
|
| ||
Orient the Backrest (14) and the Backrest |
|
|
| |
Backing (8) as shown. Attach the Backrest and |
|
|
| |
the Backrest Backing to the Backrest Frame (15) |
|
|
| |
with four M6 x 45mm Screws (58). | 8 |
|
| |
|
|
| ||
| 15 |
| 53 | |
|
|
| 62 | |
|
| 58 |
| |
| 54 | 58 |
| |
13. Insert the rod on the Backrest Frame (15) into the | 13 |
|
| |
slot in the Seat Carriage (12). Hold the Backrest |
|
| ||
|
|
| ||
Frame vertically over the Seat Carriage and |
|
|
| |
slide the rod into the slot, as shown in the |
|
|
| |
inset drawing. |
|
|
| |
| Rod |
|
| |
| 15 |
|
| |
|
| 15 | ||
|
| Rod | ||
|
|
| Slot | |
| 12 |
|
| |
|
|
| 12 | |
14. Press two 50mm Round Inner Caps (57) into the | 14 |
|
| |
top and bottom of the Leg Developer (19). Press |
|
| ||
|
|
| ||
two 45mm Round Inner Caps (56) into the top |
| Tube | 57 | |
and bottom of the Leg Lever (7). |
|
|
| |
Lubricate an M10 x 69mm Bolt (60) with grease. |
| 76 |
| |
56 |
|
| ||
Attach the Leg Lever (7) to the Leg Developer |
| 60 | ||
78 |
| |||
(19) with the Bolt and an M10 Nylon Locknut (76). | 19 | |||
Tube |
| |||
Do not overtighten the Locknut; the Leg Lever | Lubricate | |||
| 7 | |||
must be able to pivot easily. |
|
| ||
|
| 57 | ||
| 26 |
| ||
Press two 19mm Round Inner Caps (78) into the |
|
| ||
|
|
| ||
tube on the Leg Lever (7). Slide two Foam Pads |
| 78 | ||
(26) onto the tubes. Repeat with the tube on the | 56 | |||
|
| |||
Leg Developer (19). |
|
|
| |
9
