ADJUSTMENTS

This section explains how to adjust the resistance system. See the EXERCISE GUIDELINES on page 20 for important information about how to get the most benefit from your exercise program. Also, see the accompanying exercise guide to see the correct form for each exercise.

Make sure all parts are properly tightened each time the resistance system is used. Replace worn parts immedi- ately. The resistance system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. The resistance bar can be cleaned with a vinyl and rubber protectant, available at an automotive or department store.

ATTACHING THE HIGH PULLEYS

To use a high pulley, slide the hook on the Pulley Housing (39) onto an hook on the Top Frame (37). Attach the end of the High Cable (101) without the ball to the end of the Lower Cable (115) with a Cable Clip (94). Attach the other high pulley in the same manner.

Remove the high pulleys when not in use.

USING THE LEG LEVER

To use the Leg Lever (56), attach it to the Leg (5) with a Leg Station Pin (60). Slide a Cotter Pin (138) onto the Leg Station Pin.

Route the hook end of the Leg Lever Cable (102) under the 90mm Pulley (40) in the Leg (5), and attach it to the Leg Lever (56). Make sure the hook is ori- ented as shown when attaching it to the Leg Lever. Insert a Leg Station Pin (60) into the Leg, under the Cable. Slide a Cotter Pin (109) onto the Leg Station Pin.

See the inset drawing. Attach a long end of the Leg Lever Cable (102) to one end of the Lower Cable

(114)with a Cable Clip (94). Attach the other long end of the Leg Lever Cable to the other end of the Lower Cable in the same manner.

37

 

39

 

Ball

 

101

 

115

 

94

 

56

138

5

 

40

 

102

60

138

 

60

 

Hook

 

94

 

102

 

114

 

13

Page 13
Image 13
Weider WESY75741 Adjustments, Attaching the High Pulleys, Remove the high pulleys when not in use, Using the LEG Lever