ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (36) on the indicated pin on the Front Upright (42). Attach the Seat Frame to the Front Upright with the 5/16Ó x 2 3/4Ó Carriage Bolt (14) and Seat Knob (40).
For some exercises, the Seat (13) must be removed. First, make sure that the chain is not attached to the leg lever. Next, remove the Seat Knob (40) and 5/16Ó x 2 3/4Ó Carriage Bolt (14) from the Seat Frame (36). Lift the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION
To use the Leg Lever (29), the seat must be attached to the front upright (see ATTACHING AND REMOVING THE SEAT on page 13). Attach the Chain (84) between the Short Cable (23) and the 5/16Ó x 2Ó Eyebolt (35) on the Leg Lever with two Cable Clips (83).
ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION
Attach the Lat Bar (85) to the Long Cable (66) with a Cable Clip (83). For some exercises, the Chain (84) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed.
The Nylon Strap (39) can be attached in the same man- ner.
17
36 | 40 |
|
14 |
|
|
Pin |
|
|
42 |
|
|
| 84 | 29 |
|
| |
|
| 83 |
23 |
|
|
|
| 62 |
66 | 83 |
|
|
| |
| 84 |
|
|
| 85 |
| 39 |
|
