GOLD CGs 
10a Service and maintenance — schedule
VERIFY PROPER OPERATION AFTER SERVICING
Table 5 Service and maintenance schedules
Service technician
(see following pages for instructions)
| Inspect: | |
| • Reported problems | |
| • | Boiler area |
| • | Air openings |
| • | Flue gas vent system (and air piping) |
| • | Pilot and main burner flames |
| • | Water piping |
| • | Boiler heating surfaces |
| • | Burners, base and inlet air box |
UP | • Condensate drain system | |
- |
|
|
TART | Service: | |
| ||
S | • | Inducer motor |
|
| |
ANNNUAL | • | |
| ||
| ||
| • | Perform |
| Check/test: | |
| • Gas piping | |
| • | Cold fill and operating pressures |
| • | Air vents and air elimination |
| • | Limit controls and cutoffs |
| • Expansion tank | |
| • | Boiler relief valve |
| Review: | |
| • Review with owner | |
|
|
|
Owner maintenance
(see CGs User’s Information Manual for instructions)
| • | Check boiler area | |
| Daily | • | Check air openings | |
|
| ||
| • | Check boiler pressure/ | |
|
| temperature gauge | |
|
|
| |
| • | Check boiler interior piping | |
| • Check venting system | ||
| • | Check air vents | |
| Monthly | • | Check boiler relief valve | |
| |||
| • Check condensate drain system | ||
| • | Check automatic air vents (if | |
|
| used) | |
|
|
| |
| • | Test low water cutoff (if used) | |
| Periodically | • | Clean vent termination/air intake | |
| |||
|
| screens | |
|
|
| |
| Every 6 months | • | Oil inducer motor | |
• | Operate relief valve | ||
| |||
|
|
| |
End of season • Shut down procedure
Follow the Service and maintenance procedures given throughout this manual and in com- ponent literature shipped with the boiler. Failure to perform the service and maintenance could result in damage to the boiler or system. Failure to follow the directions in this manual and component literature could result in severe personal injury, death or substantial property damage.
Part number | 37 |
