LGB (Series 2) — Control Supplement
I Installation
Table 1
Pilot burner and flame sensor locations
1.For use with
2.LOCAL INSPECTOR MUST CERTIFY BOILER FOR IRI COMPLIANCE.
3.Assemble pilot burner and flame sensor to main burners with pilot brackets. See Figures 2 and 3. Install ground wiring as shown in Figures 2 and 3.
4.Reinstall burner assemblies. See Table 1 for pilot burner and flame sensor locations.
5.Assemble control panel to boiler. See Figure 1.
6.Install gas controls as shown in Figure 4, page 4.
7.IRI installations require manual reset controls.
a.Steam boilers require a manual reset Low Water Cutoff and manual reset Pressure Limit Control.
b.Water boilers require a manual reset Low Water Cutoff and manual reset Temperature Limit Control.
Boiler Model | Flame Sensor * | Pilot Burner * | |
|
|
| |
toiAN | 2 | 9 | |
toiAP | 2 | 11 | |
toiAS | 2 | 13 | |
|
|
| |
toiAV | 2 | 15 | |
toiAFD | 2 | 16 | |
|
|
| |
toiAFF | 2 | 16 | |
toiAFG | 2 | 16 | |
| 7 n |
| |
|
|
| |
|
|
|
Figure 1
Mount control panel to jacket as shown
Panel | Front of |
| Boiler |
| Drill (3) Holes in Front |
Drill (7) 1/8“ Holes In Jacket to Mount Bracket
Drill (4) Holes in Side
55BGL
2 | Part Number |