EMI T2HA manual S2HA INSTALLATION INSTRUCTIONS, S2HA UNIT MOUNTING SECTION

S2HA INSTALLATION INSTRUCTIONS

NOTE: For T2HA installation refer to the T2HA Installation Instruction in this manual.

S2HA UNIT MOUNTING SECTION

Side discharge unit allows for permanent mounting through the feet. This is highly recommended due to the vertical design of the unit.

1.Loosen the screws on left and right sides of the front panel. (Do not remove these screws.)

2.Remove the screws on the front of the panel.

3.To remove front panel:

Accumulator Compressor Capacitor

Filter Driers

Lag Bolts

5.Insert lag bolts through the holes in the bottom of the unit and tighten to secure.

6.Insert lag bolts through the holes in the feet on the back of the unit and tighten to secure.

7.Replace the front panel, do not tighten the side screws at this time.

4.Slide front panel forward to clear side screws and remove.

Multi-zone Heat Pump Condensing Units 5 www.enviromaster.com