SERVICING INSTRUCTIONS (continued)
REPLACE HEATING ELEMENT
Remove tank lid assembly as detailed on page 10.
Remove two hex nuts holding element to cover. Pull element from mounting holes.
Reassemble in reverse order.
REPLACE SOLENOID
Unplug power cord. Turn OFF and disconnect water supply from dispenser inlet fitting.
Remove rear panel. Remove two screws holding access door in place. Remove access door and solenoid. Unscrew inlet fitting cap to release solenoid from door. Remove wiring from solenoid.
Transfer fill tube from old solenoid to new solenoid. Reassemble in reverse order.
REPAIR HOT WATER FAUCET
Unplug power cord. Turn OFF water. Unscrew bonnet from faucet, then pull bonnet assembly from faucet body.
Examine the interior of the faucet body and the surface of the seat cup. Clean out any debris in the faucet body, using a stiff bristle brush if necessary.
If required, work the seat cup out of the bonnet and off of the end of the stem. Install a new seat cup, making sure the knob on the stem is fully inserted into the pocket of the seat cup, and the skirt of the seat cup is fully inserted into the bonnet
Reassemble in reverse order.
712 76580 Owners Manual Hot Water Dispenser
IMPORTANT:
When replacing heating element, also replace seal gaskets.
NOTE: Any abrasion or roughness on the flat end of the seat cup will require replacing the seat cup:
11
