Allied Telesis AT-8624POE, 8624T/2M manual How to Install the Switch, Prepare to install the switch

8 AT-8600 Series Switch

How to Install the Switch

Warning All versions of this equipment must be earthed.

Prepare to install the switch

1.Read the safety information

Read the safety information included in this Installation & Safety Guide. This Installation & Safety Guide is also on the Documentation and Tools CD-ROM and you can download a copy from http:// www.alliedtelesis.com.

2.Gather the tools and equipment you will need

You will need a Phillips #2 flat-head screwdriver and cage nuts to attach the brackets to your rack. These are not supplied.

3.Choose a suitable operating location

Follow the guidelines described in “Selecting a Site” on page 7 to choose a suitable location.

You can install the switch either in a 19-inch rack, on a flat bench, or against a wall.

4.Unpack the switch

Verify the package contents. If any items are damaged or missing, contact your authorised distributor or reseller.

5.Install expansion modules (optional)

The only expansion module supported by the AT-8624T/2M is the AT-A46.

If you purchased expansion modules, install them now by following the instructions in the AT-A45/xx Series, AT-A46, and AT-A47 Expansion Modules Installation Guide that comes with the modules. The AT-A46 expansion module is supported by AT-8000 Series switches as well as AT-8600 Series switches.

Hot swap of expansion modules is not supported on AT-8624T/2M switches. If you insert or remove a module when the switch is already powered on, you must restart the switch before the module can be used.

6.Place the switch in its operating location If installing the switch in a rack:

•Remove the rubber feet on the bottom of the switch with a flat-head screwdriver.

•Attach the two rack-mounting brackets to the switch with the screws provided in the rack-mount kit.