MOUNT INTO
THREADED
HOLES IN WARMER
FRAME
TURN BOTTOM PORTION TO 
ADJUST
A.INFINITE SWITCH
1.On INFINITE SWITCH CONTROLLED warmers, power is applied to the heating element based on the control knob position and the amount of energy consumed.
2.The desired temperature is controlled by rotating the TEMPERATURE CONTROL KNOB. The knob may have a numeric scale, where higher numbers correspond to higher temperature. LO is the lowest temperature setting; PREHEAT is a “continuous on” setting. Infinite switch controlled warmers are equipped with a
3.On warmers equipped with an INDICATOR LIGHT, the light will glow when the infinite switch is in any position other than OFF.
4.The TEMPERATURE CONTROL KNOB will rotate without stopping, with PREHEAT and OFF having obvious detents. The OFF position is a “positive” OFF (i.e. the switch is positively held in the open position).
NOTE: Since the infinite switch is basically a timing device, no temperature sensing component is required.
B.ADJUSTABLE LEGS
1.Countertop warmers may be equipped with adjustable legs. These legs allow for:
a.leveling the warmer
b.ventilation around the warmer, and
c.cleaning under the warmer.
2.Adjustable legs are supplied with the warmer, these legs MUST be properly installed before the warmer is placed into operation. See page 11 for alternate legs.
002 p/n 303306 OpM CT Warmer_Inf. Sw.
2
