INSTALLATION (continued)
SERVICE TECHNICIAN INSTALLATION NOTES
An Ansul® technician must charge and arm the fire suppression system before the ventilator blower will operate. See page 10.
Installation and start up must be performed by an Authorized Installation Company.
Installer must complete the WARRANTY REGISTRATION form, and record appliance installation particulars on the CUSTOMER SERVICE DATA form in this manual.
Certain codes require cooking equipment to be restrained with a RESTRAINT DEVICE. It is the RESPONSIBILITY OF THE INSTALLER to check with the AUTHORITY HAVING JURISDICTION, in order to ascertain the applicability of this requirement to THIS SPECIFIC EQUIPMENT INSTALLATION. Any restraint device must allow access to the back and sides of the unit to provide for servicing and maintenance, and must not interfere with the operation of the FIRE SUPPRESSION SYSTEM.
IMPORTANT!
Verify that this VENTILATOR and food cooking equipment installation is in compliance with the specifications listed in this manual, with local code requirements, and in accordance with N.F.P.A 96
(THE STANDARD FOR VENTILATION CONTROL AND FIRE PROTECTION OF COMMERCIAL COOKING OPERATIONS - current edition).
THIS IS THE
RESPONSIBILITY
OF THE INSTALLER
ELECTRICAL INSTALLATION
Refer to the nameplate on the cooking appliance to verify the ELECTRICAL SERVICE POWER. Voltage and phase must match the nameplate specifications, and available electrical service amperage must meet or exceed the specifications listed on page 1. Incoming wiring must comply with National Electrical Code specifications.
All universal hood appliances ship from the factory wired 3ø and include a 3ø cordset.
For 1ø operation:
a.Remove rear lower panel (item 12)
b.Refer to the wiring schematic diagram located on the inside of the panel.
c.Service wiring and conduit, or appropriate cordset must be provided by the electrical installer.
d.Wiring change must be performed by a licensed electrician.
e.Be sure to reinstall the panel when wiring change is completed.
DANGER
ELECTRIC SHOCK
HAZARD
ELECTRIC CONNECTIONS MUST BE MADE BY A LICENSED ELECTRICIAN Electrical shock will cause death or serious injury.
NOTE: This appliance requires a dedicated 60 Amp electrical branch circuit protection.
IMPORTANT:
Contact a licensed electrician to install and connect electrical power to the appliance.
IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.
9
