8.Set the Console Assembly (91) on the Right Upright (54) and the Left Upright (not shown). Next, start four M8 x 70mm Bolts (3) with four M8.5 Washers (13) and four
M8 Star Washers (10) (only two of each are shown) into the Right Upright and the Left Upright. Then, tighten all four Bolts.
Insert the slack in the Wire Harness (98) down into the Right Upright (54).
Attach the Console (93) to the Console Assembly (91) with four M4.2 x 16mm Screws (7). Make sure that the
Wire Harness (98) is in the indicated slot in the Console Back and that no wires are pinched.
9.Carefully lower the Handrails (55, 56) to the floor. Center the Frame (51) between the Handrails, and tighten the four M10 x 58mm Bolts (2) (see step 1). Then, raise the Handrails back to the vertical position.
See the inset drawing. Attach the Latch Assembly (102) to the Left Upright (53) with two M4.2 x 16mm Screws
(7). Make sure that the Latch Assembly is oriented as shown.
See HOW TO CHANGE THE INCLINE OF THE TREAD- MILL on page 15. Adjust the incline of the treadmill as desired.
8 |
|
|
|
91 | Slot |
|
|
54 |
|
|
|
|
|
| 7 |
98 |
|
| 93 |
|
|
| |
| 10 |
| 7 |
| 13 |
|
|
| 3 |
|
|
9 |
|
|
|
|
| 51 | 2 |
|
|
| |
|
| 55, 56 |
|
53
102
7
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 19). To protect the floor or carpet, place a mat under the treadmill.
10
