TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 11). Use only a | ||
sor that meets all of the specifications described on page 11. IMPORTANT: The treadmill is not | ||
compatible with | ||
outlets. |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the power switch located on the treadmill | c |
|
frame near the power cord. If the switch protrudes |
| |
as shown, the switch has tripped. To reset the |
|
|
switch, wait for five minutes and then press the | Tripped | Reset |
switch back in. | ||
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c.Remove the key from the console. Reinsert the key into the console.
d.If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE | a |
| 20 |
POWER CORD. Remove the three indicated M4.2 x | 65 | ||
19mm Washer Head Screws (20) and two M5.5 x |
|
| |
25mm Screws (25). Then, carefully remove the Hood |
|
|
|
(65). |
| 25 |
|
|
|
|
Locate the Reed Switch (89) and the Magnet (62) on |
|
|
the left side of the Pulley (71). Turn the Pulley until | 1/8 in. |
|
the Magnet is aligned with the Reed Switch. Make | 71 | |
sure that the gap between the Magnet and the |
| |
Reed Switch is about 1/8 in. (3 mm). If necessary, | 89 | 62 |
loosen the M4.2 x 13mm Tek Screw (3), move the | ||
Reed Switch slightly, and then retighten the Screw. | Top View |
|
Reattach the Hood (not shown), and run the treadmill |
| |
for a few minutes to check for a correct speed read- |
|
|
ing. |
|
|
18
