3.Attach the Console Plate (81) to the Handrail Crossbar (83) with two M8 x 16mm Bolts (1) and two M8 Star Washers (5). Make sure the
Console Plate is oriented as shown and that the Wire Harness (84) is not pinched. Remove the wire tie from the Wire Harness (84).
3 | 83 | 81 |
|
84 |
5 1
5 1
Wire Tie
4.Remove the console back and the four M4.2 x 12mm Screws (3) from the Console (80). Save the console back and the Screws for step 6. Hold the Console (80) near the Console Plate (81). Touch the Console Plate to discharge any static.
Next, press the connector on the end of the Wire Harness (84) into the connector on the back of the Console (80) in the location shown.
See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn the connector on the Wire Harness and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
4 |
| 80 |
|
Connector |
| ||
Console | 84 |
| 81 |
Back |
| ||
|
| 3 | Connectors |
| 3 |
| 84 |
8
