12.Attach a Large “U” Bracket (56) to one of the Arms
(46)with a 3/8” x 2 1/2” Bolt (62), 3/8” Flat Washer
(9)and 3/8” Nylon Lock Nut (21).
Lubricate a 5/16” x 2” Bolt (61). Attach a Narrow Swivel Bracket (58) to the Large “U” Bracket (56) with the Bolt and a 5/16” Jam Nut (2). Do not overtighten the Jam Nut; the Narrow Swivel
Bracket must be able to swivel freely.
Attach a Large “U” Bracket (56) and Narrow Swivel Bracket (58) to the other Arm (46) in the same manner.
12
58
56
2
58
21
56
2
46
21 | 9 |
9
62 62
46
13. Attach the Wide Swivel Bracket (71) to the bracket on the side of the Top Frame (67) with the 5/16” x
3 1/4” Bolt (76) and a 5/16” Nylon Lock Nut (3). Do not overtighten the Nylon Lock Nut; the Wide
Swivel Bracket must be able to swivel freely.
14.Insert two 3/8” x 1 3/4” Bolts (12) through the two “I” Plates (78) and the two 4 1/2” Pulleys (77) as shown. Finger tighten two 3/8” Nylon Lock Nuts
(21) onto the ends of the Bolts. Do not thread the
Nylon Lock Nuts all the way onto the Bolts until after assembly step 22 is completed.
15.IMPORTANT: As you assemble the Long Cable
(66)and the Short Cable (not shown), refer to the CABLE DIAGRAM on page 18 of this
owner’s manual to make sure that the Cables are properly routed.
Find the end of the Long Cable (66) that has a metal eyelet without a rubber ball. Insert that end of the Long Cable up through the indicated opening in the Top Frame (67).
Lay the Long Cable (66) over a 4 1/2” Pulley (77). Attach the Pulley inside the Top Frame (67) with a
3/8” x 2 3/4” Bolt (70), two 3/8” Flat Washers (9), two 1/2” x 1/2” Spacers (65) and a 3/8” Nylon Lock Nut
13
76
67
3 | 71 |
14
77
12
|
|
| 78 |
| 21 |
|
|
|
| 77 |
|
| 78 |
|
|
15 | 66 | 77 |
|
|
| ||
| 65 | 65 | |
|
|
| |
| 9 |
| 21 |
|
|
| |
|
|
| 9 |
| 70 |
| 67 |
|
|
|
8
