CONSOLE DIAGRAM
Note: If there is
a 
thin
sh
eet
of
clear
p
lastic
on
the
face
of
the console, remove it before operating the console.
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turn- ing on the power.
•Always wear the clip (see the drawing at the lower right) while using the treadmill. When the key is removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•The training zones marked beside the speed control are general guidelines only. See page 14 for more information.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
BATTERY INSTALLATION
The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. Open the battery cover as shown in the drawing at the upper right. Insert two batteries into the console, making sure that the negative
Battery |
Cover |
Tab |
Batteries |
Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
Stand on the foot grips of |
|
|
|
|
|
|
the treadmill. Find the clip |
| Clip |
|
|
|
|
|
|
|
|
| ||
attached to the key and |
|
|
|
|
|
|
slide the clip onto the waist- |
|
|
|
|
|
|
|
|
|
|
|
| |
band of your clothing. Next, |
|
|
|
|
|
|
|
|
|
|
|
| |
insert the key into the con- |
|
|
|
|
|
|
sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.
8
