Char-Broil 466231203 manual Important Bracket with cut-out installs on front left

8.	Attach the door bracket to the lower holes in the front legs
	with the end tabs pointing upward and the flange to the rear,
	pointing downward. Use 2 of the 1/4x1/2" Phillips-head
	screws. Do not fully tighten. See Fig. 4.
9.	Place doors into the hinge holes of the bottom shelf and
	door bracket. Push door bracket down until doors are
	secure and can open and close freely. Do not fully tighten
	door bracket screws. See Fig. 4.
10.	Remove protective film from doors. Install door handles to
	doors using 4 of the 3/16x3/8" Phillips-head screws. See
	Fig. 4.

13.Attach match lighting stick and chain to the right rear leg, below shelf bracket, using one M4x10mm, self-tapping, Phillips-head screw. See Fig. 5.

FIGURE 5

Match lighting stick

11.	Attach the 4 side shelf brackets to the tops of the cart legs
	using 8 of the 1/4x1/2" Phillips-head screws.
	IMPORTANT: Bracket with cut-out installs on front left
	leg. Be sure the flat side of each bracket faces outward.
	Fully tighten. See Fig. 4.
12.	Place the sideburner shelf over the left brackets and cross
	brace. Be sure ignitor wire is hanging loose. Be sure the
	inside shelf holes align with cross brace holes. Secure
	shelf firmly to the ends of the brackets using 2 of the
	1/4x1/2" Phillips-head screws. Repeat this procedure for
	the side shelf on the right side of the cart. See Fig. 4.

FIGURE 4

Sideburner shelf

Side shelf

To reduce the weight of the grill head, open the grill lid and remove the packed components. This step requires 2 people to lift and position the grill head onto the cart.

14.HINT: Slide grill head into cart from the front. Use care to avoid scratching tops of side shelves. Align the 2 holes beneath the hang ledge on each side of the grill head with the 2 holes in the side shelf and cross brace on the cart. Raise the grill lid and insert 4 of the 1/4x3/4" Phillips-head screws. Beneath the side shelves, add 1/4" nuts. Do not fully tighten. See Fig. 6.

15.Attach heat indicator to grill lid using nut provided. Make

sure graphics on heat indicator are properly oriented before tightening nut. See Fig. 6.

FIGURE 6

Grill head

Align holes

Heat indicator

Hang ledge

Bracket with cut-out

Lower hole

Shelf bracket, flat side facing outward

	Door
	bracket
	Hinge
Door	hole
Handle
Remove	Hinge
film

Gas hose	Hang
	ledges
	rest on
	shelves

466231203 • 7