Char-Broil 466231203 manual Before Attaching Regulator to LP Tank, See Fig

16.Firmly attach ignitor wire from sideburner to the ignitor wire from the grill head. See Fig. 7a. Beneath left shelf, insert sideburner valve into sideburner tube. See Fig. 7 for proper engagement. Attach sideburner valve to shelf using 2 of the M4x10 Phillips-head screws and washers. Place knob seat, spring, and sideburner knob over valve stem.

FIGURE 7	Sideburner
	tube

Sideburner	Spring
knob
Valve
Seat

FIGURE 7a

Ignitor wire

Valve

Wire from Grill head

17.Secure grill head to all cart legs using 4 of the 1/4x2-1/2"Phillips-head screws and 1/4" nuts. See Fig. 8.

18.Fully tighten all leg screws, rear panel screws, door bracket screws, and grill head screws.

19.From the back of the cart, slide the grease draining tray into the grill head. Place the grease receptacle into the notches on the bottom of the tray. See Fig. 8.

FIGURE 8	Grease
	draining
	tray

Grease receptacle

Attach grill head to all 4 legs

20.Place your LP gas tank (not included) onto the pull-out tank tray and push tray into cart. Be sure the tank valve is facing forward. See. Fig. 9. READ USE & CARE SECTION

BEFORE ATTACHING REGULATOR TO LP TANK.

FIGURE 9

LP gas tank

21.Unscrew the ignitor cap located on the control panel and remove the contact and spring from the ignitor slot.

See Fig. 10.

22.Place the supplied AA battery into the ignitor slot with the positive pole facing toward you.

23.Place the spring with contact over the battery. Screw the ignitor cap back onto the control panel.

FIGURE 10

Spring

Contact

–

Ignitor	+
cap

AABattery

24.Attach panel to front of sideburner shelf by placing top lip of panel ABOVE bottom lip of shelf. Secure using three 3/16"x3/8" Phillips-head screws and 3/16" nuts. Fully Tighten. See Fig. 11.

FIGURE 11

Panel lip

Shelf lip

8 • 466231203