Intel SE7500CW2 manual Installing the Processor Wind Tunnel, Attaching the Heat Sink

Attaching the Heat Sink

1. Align the heat sink with the retention brackets and place the heat sink on the processor.

1

3

3

OM14474

Figure 14. Attaching the Heat Sink

2.Position the retention clip over the plastic tab and engage the clip end-slot over the plastic tab.

3.Press downward on the retention clip ends until they engage the plastic tabs.

Installing the Processor Wind Tunnel

Attaching the Processor Wind Tunnel Assembly

Install the processor wind tunnel center section over the heat sink (Figure 15). Note that the plastic tabs engage the tabs on the retention clips.

OM14475

Figure 15. Attaching the Wind Tunnel Assembly

58 Intel Server Board SE7500CW2 Product Guide