Intel SE7500CW2 manual Installing the Optional SCSI Add-inCard

Installing the Optional SCSI Add-in Card

Certain versions of the Server Board SE7500CW2 ship with an Ultra160 SCSI card. This card has the following features:

•Ultra160 single channel based on the LSI† 53C1000 SCSI controller

•PCI 2.2 compliant

•PCI 64-bit/66 MHz

•Universal PCI form factor

•Low profile form factor, shipping with a full-size bracket attached and a low-profile bracket in the packaging

•Internal and external connectors (internal standard 68 pin HD, external VHDI connector)

•Termination: Universal (LVD/SE) termination, automatic cable detection, software disable

•Four-pin header for off-board LEDs

Drivers for this card can be downloaded from the Server Board SE7500CW2 System Resource CD that ships with the board or from the Server Board SE7500CW2 Intel Support Web site:

http://support.intel.com/support/motherboards/server/SE7500CW2

✏NOTE

In order to maximize airflow within the chassis, it is recommended that you install the SCSI add-in card in either PCI slot 2 or 3 and install SCSI devices in the chassis lower device bays. However, the SCSI add-in card can be installed in any PCI slot on the server board.

1.Remove the screw that secures the filter panel at PCI slot 2 or 3.

2.Remove the filter panel at PCI slot 2 or 3 by pushing it out from the inside of the chassis.

3.Insert the SCSI card.

4.Replace the screw.

60 Intel Server Board SE7500CW2 Product Guide