Intel SE7500CW2 manual ECP default Default, IRQ7 default, DMA 3 default

Table 10. I/O Device Configuration Submenu (continued)

Feature

Mode

(This feature is present only when Parallel Port is set to Enabled)

Base I/O Address (This feature is present only when Parallel Port is set to Enabled)

Interrupt

(This feature is present only when Parallel Port is set to Enabled)

DMA channel

(This feature is present only when Parallel Port is set to Enabled)

Floppy disk controller

Choices

•Output only

•Bi-directional

•EPP

•ECP (default)

•378 (default)

•278

•3BC

•IRQ5

•IRQ7 (default)

•DMA 1

•DMA 3 (default)

•Disabled

•Enabled (default)

Description

Sets the mode for the parallel port.

Output only is the standard printer connection mode.

Bi-directionalis the standard bidirectional mode.

EPP is Enhanced Parallel Port mode, a high-speed bidirectional mode. Selection based on what EPP version the printer supports. Only choose a mode that the parallel port device (such as a printer) supports. Check the parallel port device documentation for this information. If this information cannot be located, use the default setting.

ECP is Extended Capabilities Port mode, a high-speed bidirectional mode.

Sets the base I/O address for the parallel port.

Sets the interrupt for the parallel port.

Sets the DMA channel for the parallel port.

Enables or disables the onboard diskette controller.

30 Intel Server Board SE7500CW2 Product Guide